DARAY X340, Operating & Installation Manual

Page: 33 / 48

Page 32 of 43
Rubber Retainer
Ring
Ceiling Mount Cover Suspended Ceiling
Mount Cover
Feed Cable
Through
Now you should put the rubber retainer ring onto the downtube followed by either
the ceiling trim or ceiling mount cover. This is to allow the covers to be fixed into
position after you have attached the downtube to the ceiling plate.
Thread the wire back through the downtube and the hole in the middle of the ceiling
plate; then place the downtube between the clasps on the ceiling plate. Slide the
safety bolt through the clasps and the downtube (being careful not to catch the
wire). Be sure to tighten the safety bolt and the nylon locknut.
It will be necessary to ensure that the downtube is absolutely vertical. To prevent
arm drift. This can be achieved by adjusting the three bolts on the plate, then use
the locking nut on the bolts to lock the adjustment. After any adjustment it will be
necessary to check that all fixings are still sound and that locking nuts are tight.
Now push the ceiling cover up onto the mounting bracket and roll up the rubber
retaining ring to stop the cover from dropping back down.
Locking Nut
Adjusting Bolt