Page
39
of 49
7.4 System Setup
Select the SYSTEM SETUP item in the [SYSTEM MENU]. The following menu will pop up:
Time -
Users can set the system time by selecting the [TIME] function. When in the time section
you can switch between hours minutes and seconds, when you have selected the one you want to
change press ok, this will highlight the selected section turning the border red and the text white,
then use the up and down keys to adjust, once adjusted press ok again to confirm. To exit move
the selection down to the exit key and press ok.
Default –
Selecting the [DEFAULT] key will return the monitor to its default factory settings.
New Patient –
In the setup menu is a [NEW PATIENT] key. Selecting this and moving the function
to [YES] and confirming, will bring up a new screen asking you to confirm the new patient with a
“Clear the last value?” confirmation. Selecting [YES] again will delete the measurement record of
the previous patient. If you select [NO] on this screen it will take you back to the [SYSTEM SETUP]
screen.
As this function wipes the previous patients measurement records please be careful / aware of
this function.
Never power off or disassemble the instrument during record deletion as it could
cause an error when saving new data. The same precaution should be taken when
the device is communicating with PC software.
Alarm -
If users select the [ALARM] key and switch it [ON], the loudspeaker will turn on and an
icon
will show in the main interface. On the other hand, when users select [OFF], the
loudspeaker turns off, and
will display on the main screen.
Function Selection –
The V460S has two functions PM and ABPM for the [FUNCTION SELECT] key.
These two functions have corresponding measurement parameters which will change accordingly.
When in PM mode backlight time is disabled and so is the ABPM info tab on the main system menu.
When in ABPM mode the Default and new patient keys are disabled. The SpO
2
measurement
details are also disabled.
Backlight time -
In the [BACKLIGHT TIME] function, users can set a time from 5 to 120 seconds
with 5 seconds per step. Its function is to control the backlight time of the main interface in ABPM
mode. Under ABPM, [DEFAULT] and [NEW PATIENT] cannot be set-up.
Summary of Contents for V460S Series
