Page
45
of 49
Reusable Blood Pressure Cuff
The cuff can be sterilized by means of conventional autoclaving, gas, or radiation sterilization in
hot air ovens or disinfected by immersion in decontamination solutions, but remember to remove
the rubber bag if you use this method. The cuff should not be dry-cleaned.
The cuff can also be machine-washed or hand-washed, the latter method may prolong the service
life of the cuff. Before washing, remove the latex rubber bag, and for machine-washing, close the
Velcro fastening. Allow the cuff to dry thoroughly after washing, then, reinsert the rubber bag.
Replacing the Rubber Bag in the Cuff
To replace the rubber bag in the cuff, first place the bag on top of the cuff so that the rubber
tubes line up with the large opening on the long side of the cuff. Now roll the bag lengthwise and
insert it into the opening on the long side of the cuff. Hold the tubes and the cuff and shake the
complete cuff until the bag is in position. Thread the rubber tubes from inside the cuff, and out
through the small hole under the internal flap.
Disposable Blood Pressure Cuffs
Disposable cuffs are intended for one-patient use only. Do not use the same cuff on any other
patient. Do not sterilize or use autoclave on disposable cuffs. Disposable cuffs can be cleaned
using soap solution to prevent infection.
8.4 Disposal
To avoid contaminating or infecting personnel, the environment or other equipment, make sure
you disinfect or decontaminate the device appropriately before disposing of it.
All disposal must be completed in accordance with your country’s laws and local governing rules /
regulations for equipment containing electrical and electronic parts.
For SpO2 sensor, NIBP cuff and other accessories; follow local regulations regarding disposal of
hospital waste.
Battery disposal must be in compliance with the local recycling instructions and should not be
fired or autoclaved.
8.5 Transportation and Storage
A. The packed device can be transported by ordinary conveyance or according to transport
contract. The device cannot be transported mixed with toxic, harmful, or corrosive material.
B. The packed device should be stored in a room with no corrosive gases and good ventilation.
Temperature: -20°C~60°C; Humidity: ≤95%.
Summary of Contents for V460S Series
