DAPAudio D2250, Manual

Page: 24 / 43

TIP(Hot) SLEEVE(GND)
RING(COLD)
（1/4＂Phone 3 Section Connector）
INSERT OUT
INSERT IN
2. PHANTOM POWER SWITCH
When is the “ ON ” position, 48V DC phantom power will be provided between pin 2 and 3 of the XLR-type
jack. if you do not need phantom ,be sure to turn this to the “ OFF ” position.
3. BALANCED LINE INPUT CONNECTORS
A standard 1/4 ″ phone jack is used for balanced or unbalanced line level signals.
Examples of line level signals include most electronic keyboards ,synthesizers ,turn-tables ( with appropriatepre-
amps),tape decks and the line outputs from other mixers. All input channel controls, including the variable GAIN
control, affect the LINE input Maximum input level before preamp clipping is 12V or +24dB.
4. INPUT CHANNEL INSERT
These are input/output jacks located between the head-amplifier and the high pass filter.
The nominal input level and impedance is 0dB/600 Ω ,and the nominal output level and impedance is 0dB/10k Ω .
These jacks allow you to own graphic equalizers, compressors, noise filters ,or other devices.
5. DIRECT OUT CONNECTORS
These are unbalanced 1/4 ″ phone jacks which output the post-fader signal independently from each input channel.
The channel strip's output signal is always available at the DIRECT OUT connector.
Using it does not interrupt the normal signal flow through the channel.
Nominal level and lmpedance is 0dB/10k Ω .
8 BUS MIXING CONSOLE
23