DAPAudio D2250, Manual

Page: 10 / 43

1 1
2
7
3
4
5
6
8
10
9
1. PEAK INDICATOR
This indicator detects peak level after EQ.It will light red at 3dB
before clipping to warn that clipping level has nearly been
reached.
2. SIGNAL INDICATOR
This indictor detects signal level after the EQ . It will light green
at -10dB.
3. EQ CONTROLS(HIGH,LOW)
This is a 2-band frequency fixed equalizer with center fre-
quencies range and type as shown below.
HIGH: 12Hz, ± 15dB shelving type
LOW: 80Hz, ± 15dB shelving type
4. AUX SEND CONTROLS
This knobs controls the level of the signals sent to Aux buses.
- The AUX 1&2 controls the STEREO channel 1 &3 PANEL
are pre-fader and the signal levels sent to the AUX 1 & 2 buses
will be unaffected by the channel fader setting.
- The AUX 3&4 controls on the STEREO 2&4 PANEL are
post-fader and the signal levels sent to the AUX 3&4 buses will
beaffected by the channel fader setting.
5. BALANCE CONTROL
T his control adjusts the balance or the L/R position of the stereo
input signal.
Turning the BALANCE control to left of center moves the
apparent source toward the MAIN MIX L and Group 1, 3, 5, 7
buses, turning it to the right move the source toward the MAIN
MIX R and Group 2,4,6,8 buses.
6. L/R (STEREO) SWITCH
When these switches are on, the signal of each channel will be
sent to the MAIN MIX L/R buses. When this switch is of, the
output signal to MAIN MIX L/R buses will be muted.
2. STEREO INPUT SECTION
8 BUS MIXING CONSOLE
9