7
AS-8
Ordercode: D1904
Fig. 02
Balance/Pan control (CH1-6)
Turn the control to set the balance between the left and right main signals. In Splitter mode, the
main input signal will be sent to the mono output while the Balance control determines the balance
between the left and right main signal portions. In Mixer mode, the mono inputs will be mixed and
routed via the Level control to the main outputs, while the Pan control determines the allocation of
the mono inputs to the left/right main outputs.
Power Switch ON/OFF
Backside
Fig. 03
IEC 230V AC power connector IN + Fuse T3,15mAL/250V
Jack 6,3 mm connector – Balanced MONO IN/OUT (CH5-6)
3-pin XLR connector – MONO OUT (CH1-4)
3-pin XLR connector – MONO IN (CH1-4)
3-pin XLR connector – Main OUT
The main outputs may be fed by the left/right main inputs or by any of the 6 mono inputs
(combination of both is also possible).
3-pin XLR connector – Main IN
While operating in Splitter mode, the main inputs may feed the mono outputs of all channels.
Installation
Remove all packing materials from the AS-8. Check that all foam and plastic padding is removed.
Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Summary of Contents for AS-8
Page 15: ...14 AS 8 Ordercode D1904...
Page 16: ...2016 DAP Audio...
