Dannmar DB-70, Installation And Operation Manual

Page: 38 / 68

DB-70 Automatic Wheel Balancer
38
P/N 5900261 — Rev. A1 — January 2021
h. Input the center plane parameters. Slide the inner distance arm to the center plane and
hold it there until the Balancer beeps. This automatically determines the distance from the
side of the Balancer to the center plane and the wheel diameter (
a2 and d2 ), then places
the parameters into the Balancer’s memory. You may also enter the values manually using
the
A
and
D
keys.
Important: If the values appear incorrect, you can turn off the power to reset the machine
and start the process over.
i.
Determine the width of the wheel using the
wheel caliper and input this value using the
front panel button labelled B . The value
should appear in the Outer Display Window .
When all three measurements are correct, you are done entering measurements.
j. Close the Tire Cover; the Wheel spins briefly.
⚠
WARNING Stay clear and do not touch the Wheel or the Tire while it is rotating.
The Balancer will automatically rotate and test the wheel for balance, unless the Tire Cover
switch is in the off position. If the Tire Cover switch is off, then lower the Tire cover and
manually start the test using the start button on the control panel.
The front panel display will show the unbalanced weight correction values for both the inner
and outer wheel planes. These values are rounded to the nearest .25 oz. Press
F
to view
the actual unbalanced weight without rounding. If either window displays 0.0 no corrective
weights are required on that plane.
k. Check the value on the Inner Window.
•
If the value is 00 , you do not need to add weight to the Inner Edge.
•
If there is a value— .25 , for example—you need to add that amount of Weight to
the Inner edge.