DB-70 Automatic Wheel Balancer
31
P/N 5900261 — Rev. A1 — January 2021
6.
Select the balance mode based on the wheel.
7.
Press R until the
STA
Mode is displayed as shown here.
8.
Input the wheel parameters. Slide the inner distance arm to touch the
center plane of the Wheel rim and hold in place. The Balancer will beep and enter
the distance and diameter automatically into the Balancer’s memory. The value
should appear in the Outer Display Window. Alternatively, you may read this
value off the inner measuring arm and enter it manually using the A and D key.
9.
Return the inner measurement arm to its rest position inside the Balancer.
Note
: If the values appear incorrect you can turn off the power to reset the machine and start the
process over.
10.
Determine the width of the wheel using the wheel caliper and input this value using the front panel
button labelled B. The value should appear in the Outer Window.
11.
When all three measurements are correct, you are done entering measurements.
12.
Close the Tire Cover. The Balancer will automatically rotate and test the wheel for balance, unless the
Tire Cover switch is in the off position. If the Tire Cover switch is off, then lower the Tire cover and
manually start the test using the start button on the control panel.
⚠
WARNING
Stay clear and do not touch the Wheel or the Tire while it is rotating.
13.
The front panel display will show the unbalanced weight correction values for the center wheel plane.
These values are rounded to the nearest .25 oz. Press F to view the actual unbalanced weight without
rounding. If both windows display 0.0 no corrective weights are required on that plane.
14.
Depress the brake with your foot to stop the wheel.
15.
Note the value displayed in the display windows. These amounts are the weights required to correct
the wheel imbalance. Locate and prepare the correct weight quantities.
16.
Open the Tire cover, release the brake and slowly rotate the wheel manually. Note the Indicator lights
to the
right
of the
Inner Display Window
. When all the lights are lit and the Balancer sounds three
beeps, the wheel has reached the position to attach the adhesive correction weight(s) on the central
plane. Hold the wheel in place using the brake and apply the weight(s) at the 12 o’clock position on the
center plane of the wheel.
17.
Lower the Tire Cover to spin and test the Wheel again. The Wheel is balanced when the Display
Windows show
0.0
.
It may take more than one time adding weights to get to
0.0 | 0.0
.
Summary of Contents for DB-70
