VLT
®
FCM Series
Installation
■
Control panel (175NO131)
The FC motor optionally features a Local Control
Panel- LCP 2 which makes up a complete interface
for operation and monitoring of the FC motor.
IP 65 on front.
NB!:
The LCP from the VLT 5000 Series (code
number 175Z0401) cannot be used for the
FC motor. However, the general LCP 2 (code
number 175N0131) can be used for both the FCM
300, VLT 2800 and the VLT 5000 Series.
■
LCP installation
The LCP 2 is connected to the terminal X100, 1-4
(see separate instruction MI.03.AX.YY).
1. Service Plug Kit (175N2546) (see section
Service
plug kit
) and cabel 175N0162
2. Plug kit (175N2545) (see section
Plug kit
)
and cabel 175N0162
3. Remote mounting kit (175N0160) (see section
Remote mounting kit
)
■
LCP functions
The functions of the control panel can be
divided into three groups:
•
display
•
keys for changing program parameters
•
keys for local operation
All data are indicated by means of a 4-line alphanumeric
display, which in normal operation is able show
4 measurements and 3 operating conditions
continuously. During programming, all the information
required for quick, effective parameter Setup of the
FC motor will be displayed. As a supplement to the
display, there are three LEDs for voltage, warning and
alarm. All program parameters of the FC motor can be
changed immediately from the control panel, unless
this function has been blocked via parameter 018.
■
Display
The LCD-displayhas rear lighting and a total of 4
alpha-numeric lines together with a box that shows
the direction of rotation (arrow) and the chosen
Setup as well as the Setup in which programming
is taking place if that is the case.
12345678
SETUP
1
12345678901234567890
12345678901234567890
12345678901234567890
175ZA443.10
1st line
2nd line
3rd line
4th line
1st line
shows up to 3 measurements continuously
in normal operating status or a text which
explains the 2nd line.
2nd line
shows a measurement with related
unit continuously, regardless of status (except
in the case of alarm/warning).
3rd line
is normally blank and is used in the menu
mode to show the selected parameter number or
parameter group number and name.
4th line
is used in operating status for showing
a status text or in data change mode for showing
the value of the selected parameter.
MG.03.H3.02 - VLT is a registered Danfoss trademark
23
