Danfoss VLT AutomationDrive FC 300, Operating Instructions Manual, Page: 54 / 60

FC 300 Operating Instructions
Troubleshooting
No. Description Warning Alarm/Trip Alarm/Trip locked
1 10 Volts low X
2 Live zero error (X) (X)
3 No motor X
4 Mains phase loss X X X
5 DC link voltage high X
6 DC link voltage low X
7 DC over voltage X X
8 DC under voltage X X
9 Inverter overloaded X X
10 Motor ETR over temperature X X
11 Motor thermistor over temperature X X
12 Torque limit X X
13 Over Current X X X
14 Earth fault X X X
16 Short Circuit X X
17 Control word timeout (X) (X)
25 Brake resistor short-circuited X
26 Brake resistor power limit X X X
27 Brake chopper fault X
28 Brake check X X
29 Drive over temperature X X X
30 Motor phase U missing X X
31 Motor phase V missing X X
32 Motor phase W missing X X
33 Inrush fault X X
34 Fieldbus communication fault X X
35 Out of frequency range X
38 Internal fault X X
47 24 V supply low X X X
48 1.8V supply low X X
49 Speed limit X
50 AMA calibration failed X
51 AMA check Unom and Inom X
52 AMA low Inom X
53 AMA motor too big X
54 AMA motor too small X
55 AMA parameter out of range X
56 AMA interrupted by user X
57 AMA timeout X
58 AMA internal fault X
59 Current limit X
61 Encoder loss (X) (X)
62 Output Frequency at Maximum Limit X
63 Mechanical Brake Low X
64 Voltage Limit X
65 Control Card Overtemperature X X X
66 Heatsink Temperature Low X
67 Option Configuration has Changed X
68 Safe Stop Activated X
80 Drive Initialised to Default Value X
(X) Dependent on parameter
LED indication
Warning yellow
Alarm flashing red
Trip locked yellow and red
54
MG.33.A2.02 - VLT is a registered Danfoss trademark