FC 300 Operating Instructions
How to Programme
Adjust Display Contrast
Hold down [STATUS] and use the up or down navigation arrow to adjust the display contrast
How to Connect a PC to the FC 300
To control the frequency converter from a PC, install
the MCT 10 Set-up Software.
The PC is connected via a standard (host/device)
USB cable, or via the RS485 interface as shown in
the section
Bus Connection
in the chapter
How to
Programme
.
USB connection.
The FC 300 Software Dialogue
Data storage in PC via MCT 10 Set-Up Software:
1.
Connect a PC to the unit via USB com port
2.
Open MCT 10 Set-up Software
3.
Choose “Read from drive”
4.
Choose “Save as”
All parameters are now stored.
Data transfer from PC to drive via MCT 10
Set-Up Software:
1.
Connect a PC to the unit via USB com port
2.
Open MCT 10 Set-up software
3.
Choose “Open” – stored files will be shown
4.
Open the appropriate file
5.
Choose “Write to drive”
All parameters are now transferred to the drive.
A separate manual for MCT 10 Set-up Software is
available.
30
MG.33.A2.02 - VLT is a registered Danfoss trademark