Danfoss VLT AAF00x, Operating Instructions Manual

Page: 47 / 103

0-65 Quick Menu Password or 0-66 Access to Quick Menu w/o
Password .
It is possible to switch directly between Main Menu mode
and Quick Menu mode.
Parameter shortcut can be carried out by pressing down
the [Main Menu] key for 3 seconds. The parameter shortcut
allows direct access to any parameter.
[Alarm Log]
displays an Alarm list of the five latest alarms (numbered
A1-A5). To obtain additional details about an alarm, use
the arrow keys to manoeuvre to the alarm number and
press [OK]. Information is displayed about the condition of
the unit before it enters the alarm mode.
[Back]
reverts to the previous step or layer in the navigation
structure.
[Cancel]
last change or command will be cancelled as long as the
display has not been changed.
[Info]
displays information about a command, parameter, or
function in any display window. [Info] provides detailed
information when needed.
Exit Info mode by pressing either [Info], [Back], or [Cancel].
Back
Cancel
Info
Navigation keys
The four navigation arrows are used to navigate between
the different choices available in [Quick Menu], [Main
Menu] and [Alarm Log]. Use the keys to move the cursor.
[OK]
is used for choosing a parameter marked by the cursor
and for enabling the change of a parameter.
130B
T117.10
OK
Back
In
fo
Warm
Alarm
On
Canc
el
Operation keys
for local control are found at the bottom of the control
panel.
130BP046.10
Hand
on
Off
Auto
on
Reset
[Hand on]
enables control of the filter via the LCP. The key can be
Enabled
[1] or
Disabled
[0] via
0-40 [Hand on] Key on LCP
The following control signals will still be active when
[Hand on] is activated:
•
[Hand on] - [Off] - [Auto on]
•
Reset
•
Stop command from serial communication
NOTE
External stop signals activated by means of control signals
or a serial bus will override a “start” command via the LCP.
[Off]
stops the unit. The key can be
Enabled [1] or Disabled [0]
via 0-41 [Off] Key on LCP . If no external stop function is
selected and the [Off] key is inactive the unit can only be
stopped by disconnecting the mains supply.
[Auto on]
enables the unit to be controlled via the control terminals
and/or serial communication. When a start signal is applied
on the control terminals and/or the bus, the unit will start.
The key can be
Enabled [1] or Disabled [0] via 0-42 [Auto
on] Key on LCP .
NOTE
An active HAND-OFF-AUTO signal via the digital inputs has
higher priority than the control keys [Hand on] – [Auto on].
[Reset]
is used for resetting the filter after an alarm (trip). The key
can be
Enabled [1] or Disabled [0] via 0-43 [Reset] Key on
LCP .
How to Operate the Active F... VLT Active Filter AAF 00x
46 MG.90.V2.02 - VLT® is a registered Danfoss trademark
5 5