5.1.10 How to Connect a PC to the Active
Filter
To control or program the Filter from a PC, install the PC-
based Configuration Tool MCT 10 Set-up Software. The PC
is connected via a standard (host/device) USB cable to
both devices, or via the RS-485 interface
NOTE
The USB connection is galvanically isolated from the
supply voltage (PELV) and other high-voltage terminals.
The USB connection is connected to protection earth on
the Active Filter. Use only an isolated laptop as PC
connection to the USB connector on the Active Filter.
130BB747.10
61 68
39 42
50
53 54
Remove jumper to activate Safe Stop
Max. 24
Volt !
12 13
12
19 27
29
32
33 20
Illustration 5.5 For control cable connections, see section on
Control Terminals
.
5.1.11 PC Software Tools
PC-based Configuration Tool MCT 10 Set-up Software
The Active Filter is equipped with one serial communi-
cation ports. Danfoss provides a PC tool for
communication between PC and filter, PC-based Configu-
ration Tool MCT 10 Set-up Software. Please consult the
MCT 10 Set-up Software software where build in literature
can reveal more usefull information.
MCT 10 Set-up Software
MCT 10 Set-up Software has been designed as an easy to
use interactive tool for setting parameters in our Active
Filters. The software can be downloaded from the Danfoss
internet site http://www.Danfoss.com/BusinessAreas/Drives-
Solutions/Softwaredownload/DDPC+Software
+Program.htm.
The MCT 10 Set-up Software will be useful for:
•
Planning a communication network off-line. MCT
10 Set-up Software contains a complete active
filter database
•
Commissioning active filters on line
•
Saving settings for all active filters
•
Replacing an active filter in a network
•
Simple and accurate documentation of active
filter settings after commissioning.
•
Expanding an existing network
•
Future developed active filters will be supported
How to Operate the Active F...
VLT Active Filter AAF 00x
MG.90.V2.02 - VLT® is a registered Danfoss trademark
49
5
5