Danfoss Heating
9
GB
6.0 Factory Reset
If for any reason you need to return the RZ1 unit to its factory reset
state, or you need to wipe all network information from the unit it is
advisable to perform a factory reset.
1. Press PROG to place the receiver in PROGRAMME mode (Red
LED illuminated continuously).
2. Press and hold CH1 button for at least 15 seconds.
3. The PROG LED will flash rapidly orange and green. Press and
hold down the PROGRAMME button for at least 15 seconds.
4. If reset was successful, the channel LEDs will show as RED and
the PROG LED will flash slowly green to indicate that the unit is
now in its factory reset state.
* if after step 1, the PROG button is not held down within 30 seconds,
the unit will return to its previous state and the full reset will not have
been applied.
Basic
Support
Binary switch
Support
Association
Control
Multi-instance
Support
Multi-instance Association
Control
Multi-command
Control and Support
Multi-channel
Control and Support
Protection Vn2
Support
Version
Support
Wakeup
Control
Thermostat Set Point
Support
7.0 Z-Wave supported and controlled classes
