RZ1 AND RZ1-HP
6
GB
3.0 Initial Startup
On initial startup the RZ1 will start up in one of two modes with the
PROG LED indicating which mode it is in.
•
PROG LED continuously ON GREEN
: The unit is in a READY
STATE.
This will be the default startup state for the RZ1 if it was
supplied with an RET BZ.
•
PROG LED slowly flashing GREEN
: The unit is in RESET STATE
and has no previous bindings/devices associated with it – the
RZ1 is ready for inclusion into an existing system or to be the
base station in a new system.
This will be the default startup state
for the RZ1 if it has been purchased individually.
To establish a link
between the RZ1 and another product please see section 4 of
the installer manual.
If on power up you have the PROGRAMME LED illuminated in any
other way, proceed to page 9 to perform a full reset.
When the RZ1 is in the READY or the RESET STATE the CHANNEL LEDs
will be in one of the following modes:
Red Channel LED flashing quickly
: The channel is pre-bound to
a controller and is waiting for communication from the associated
device. Once the remote device communicates with the RZ1 the LED
will either go out indicating there is no demand from the remote
unit, or turn green to indicate the output is active.
Red Channel LED on continuous
: No device is bound to the
channel. In this situation, please see section 4 of the installer guide
for details on establishing a link with required remote device such
as an RET-BZ.
