RZ1 AND RZ1-HP
8
5.0 Manual Override
To manually override a channel on the RZ1 receiver you need to press
the associated channel button. Depending on the output state at
time of override the Channel LED will operate in a set manner:
If the channel is already bound/associated with a wireless
device
:
If channel output is
ON
and needs to be manually switched
OFF
:
Press the channel button, the channel will switch off and the Channel
LED will
flash RED slowly
to indicate it has been manually overridden
into the off state.
It the channel output is
OFF
and needs to be manually switched on:
Press the channel button, the channel will switch on and the Channel
LED will
flash GREEN/ORANGE
.
If the channel is not bound/associated with a wireless device
:
If the channel output is on and needs to be manually switched off:
The channel LED will show
RED
to indicate output is off.
If the channel output is off and needs to be manually switched on:
The channel LED will be
ORANGE
to show that it is not associated
with a device but is overridden manually to the on state.
Manual override is cancelled if at any time the channel button is
pressed again, or the RZ1 receives a signal from an associated device
to counteract the override.
If a service interval capable unit is connected to the RZ1 receiver, the
manual override button may be disabled.
GB
