13. It is better to use wire harness anchors that will allow wires to float with respect to the machine rather
than rigid anchors.
14. Electronic modules should be grounded to a dedicated conductor of sufficient size that is connected
to the battery (-).
Electronic components welding guidelines
Remove electronic components from the machine before any arc welding. The following is
recommended when welding on a machine equipped with electronic components:
•
Turn the engine off.
•
Disconnect the negative battery cable from the battery.
•
Do not use electronic components to ground the welder.
•
Clamp the ground cable for the welder to the component that will be welded as close as possible to
the weld.
PLUS+1
®
USB/CAN Gateway
Communication (software uploads and downloads and service and diagnostic tool interaction) between
PLUS+1
®
modules and a personal computer (PC) is accomplished using the vehicle's PLUS+1
®
CAN
network.
The PLUS+1
®
CG150-2 USB/CAN gateway provides the communication interface between a PC USB port
and the vehicle CAN bus. When connected to a PC, the gateway acts as a USB slave. In this configuration,
all required electrical power is supplied by the upstream PC host. No other power source is required.
Refer to the
PLUS+1
®
GUIDE Software User Manual
, literature number 10100824, for gateway set-up
information. Refer to the
CG150-2 USB/CAN Gateway Data Sheet
, literature number L1412468, for
electrical specifications and connector pin details.
Technical Information
PLUS+1 SC0XX-1XX Controller Family
Product installation and start-up
24 |
©
Danfoss | June 2016
L1415500 | BC00000235en-US0201