HLP-V Series
8
Maximum load to ground (terminal 39) at analog output
500
Accuracy of analog output Max. error: 1.5% of full scale
Resolution on analog output.
8 bit
Reliable galvanic isolation: All digital and analog outputs are galvanically isolated from the supply voltage
(PELV)*, as well as other inputs and outputs.
Control card, 24 V DC supply
Terminal no.
12, 13
Max. load (short-circuit protection)
200 mA
Terminal nos. ground
20, 39
Reliable galvanic isolation: The 24 V DC supply is galvanically isolated from the supply voltage (PELV)*, but
has the same potential as the analog outputs.
Control card, RS 485 serial communication:
Terminal no.
68 (TX+, RX+), 69 (TX-, RX-)
Reliable galvanic isolation: Full galvanic isolation.
Relay outputs:
1)
No. of programmable relay outputs
2
Terminal nos., control card (resistive load only)
4-5 (make)
Max. terminal load (AC1) on 4-5, control card
50 V AC, 1 A, 50 VA
Max. terminal load (DC1) on 4-5, control card
25 V DC, 2 A / 50 V DC, 1 A, 50 W
Max. terminal load (DC1) on 4-5, control card for UL/cUL applications
30 V AC, 1 A / 42.5 V DC, 1A
Terminal nos., power card (resistive and inductive load)
1-3 (break), 1-2 (make)
Max. terminal load (AC1) on 1-3, 1-2, power card
250 V AC, 2 A, 500 VA
Max. terminal load (DC1) on 1-3, 1-2, power card
25 V DC, 2 A / 50 V DC, 1A, 50 W
Min. terminal load (AC/DC) on 1-3, 1-2, power card
24 V DC, 10 mA / 24 V AC, 100 mA
1) Rated values for up to 300,000 operations.
At inductive loads, the number of operations are reduced by 50%, alternatively the current can be reduced by
50%, thus the 300,000 operations are maintained.
Brake resistor terminals (only with Brake units):
Terminal no.
81, 82
External 24 Volt DC supply:
Terminal no.
35, 36
Voltage range
24 V DC
±
15% (max. 37 V DC for 10 sec.)
Max. voltage ripple
2 V DC
Power consumption
15 W - 50 W (50 W for start-up, 20 msec.)
Min. pre-fuse
6 Amp
Reliable galvanic isolation: Full galvanic isolation if the external 24 V DC supply is also of the PELV type.
Summary of Contents for Holip HLP-V Series
Page 1: ......