•
The work piece must protrude over the two bending pins by at
least 50 mm.
•
The work piece must completely bear on the cutting plate.
5.3.2 Cutting individual hoses
WARNING!
Cutting risk!
There is a risk of cutting your extremities when cutting work-
pieces.
• Make sure that no extremities are between the feed fork and
the knife protection when moving the handle.
1.
Attach the bending pin (3) at the appropriate location.
The correct position is shown by the marks on the cutting plates
(4).
2.
Insert the hose manually.
Summary of Contents for ET9500
