Danfoss ET6100, Operator'S Manual

Page: 29 / 56

5.3 Skiving the workpiece
5.3.1 Prerequisites
Prerequisites for a correct skiving process:
•
A suitable outside/inside skiving tool is selected.
•
The outside/inside skiving tool is inserted in the drive shaft.
•
The outside/inside skiving tool is secured by the locking pin /
star-shaped grip.
• The skiving length is set, see “Adjusting the skiving knives” in
Section 5.
•
The protection cover is closed.
WARNING!
Risk of squeezing
There is risk of getting squeezed between the protection cover
and the chassis when closing the protection cover.
• Use the strap grip to close the protection cover.
On the USM 10.2 S, the skiving tools are pre-adjusted by the fitter.
5.4 Outside skiving
1. Select the skiving direction using the change in direction of rota-
tion switch.
2. Press and hold down the foot pedal: the skiving tool rotates.
3. Guide the hose centrally through the guard onto the pin.
4. The hose is skived.
5. Remove the hose through the guard.
6. Release the foot pedal to stop the skiving tool.