Danfoss ET4500-001, Operator'S Manual

Page: 37 / 84

5.4 Changing the crimping dies
5.4.1 Changing the crimping dies using a die wrench
Positioning the crimping dies
1. Close the crimping tool until the holes (5) are visible for using
the locking bolt.
2. Switch off the machine using the main switch and secure it
against switching on unintentionally.
WARNING!
Risk of squeezing!
When the die system closes, there is a risk of getting squeezed
between the dies.
• Only replace the crimping dies when the machine is switched
off.
3. Use the supplied die wrench (3) to push and hold the locking
bolt backward in the basic die (1).