The SERVICE menu is used during installation and services with many settings, see
Installation instructions.
1
2
Figure 19.
The menus are reached by pressing different buttons.
Position
Description
1
Information menu
Press the left or right buttons.
2
Service menu
Press and hold the left button for at least five seconds
The INFORMATION menu is opened by pressing the left or right buttons.
For installation and service, the SERVICE menu is used, which is opened by pressing the left button for five seconds.
The indicator at the bottom of the control panel has three modes:
•
Not lit, means that the heat pump is not powered.
•
When the light shines continuously, the heat pump has power and is ready to produce heat or hot water.
•
Flashing, means an active alarm
Caution! During a service that consists of replacing the display card, all heat pump settings are reset to factory
settings. Therefore note current settings before replacement.
11.1
SERVICE menu
The SERVICE menu is for use during installation and service to optimise and adjust the operation of the heat pump.
Open the menu by pressing the left button for five seconds. Menus in italics are visible if the expansion card is installed.
Table 6.
Used to change the heat pump's default settings.
Menu
Sub menu
Sub menu
Sub menu
SERVICE
HOT WATER
START
HOT WATER TIME
HEATING TIME
TOPH. INTERVAL
TOPH. TIME
TOPH. STOP
INFL. H.W SENSOR
WEIGHT HOT WATER
HEAT PUMP
28 – Installation instructions
VMIFJ102
Summary of Contents for DHP-S&DP
Page 1: ...Installation instruc tions DHP S DP VMIFJ102 ...
Page 4: ......
