Service guide | Disassembling and Assembling, APP 11-13 and APP 16-22
© Danfoss | DCS (im) | 2017.06
180R9228 | 521B1181 | DKCFN.PI.013.V3.02 | 7
9. Place pump vertically. Place 10.5 mm pins
in port flange.
10. Position port plate by using the two pins.
Do not use force for this operation.
8. Place housing horizontally. Screw in the
rest of the screws on port flange. Tighten
screws according to exploded view.
13. Make sure there is enough free space for
the shaft beneath the housing. Minimum
100 mm (3,94 inch). Carefully lower
cylinder barrel into housing.
14. Unscrew M8 eye bolt.
11. Ensure port plate is fitted tightly against
the bottom.
IMPORTANT:
Lubricate port plate with clean filtered
fresh water.
If valve plate is disassembled from
cylinder barrel please see page 12
before continuing.
12. Screw eye bolt in cylinder barrel.
7. Screw in at least two screws from below.
WARNING!
If cylinder barrel is dropped or lowered
too fast into housing, main bearing and
shaft bearing might be damaged.
Replacement can only be done at
Danfoss, Nordborg.