Danfoss 5000 Flux, Manual, Page: 56 / 68

MG.90.D1.02 – VLT is a registered Danfoss trademark
56
VLT ® 5000/5000 Flux/6000 HVAC/8000 AQUA PROFIBUS
■ ■ ■ ■ ■
Parameter list VLT 8000 AQUA
PNU Parameter Factory setting Range Changes 4-Setup
# description during operation
600 Operating data: Operating hours No No
601 Operating data: Hours run No No
602 Operating data: kWh counter No No
603 Operating data: No. of cut-ins No No
604 Operating data: No. of overtemps No No
605 Operating data: No. of overvoltages No No
606 Data log: Digital input No No
607 Data log: Control word No No
608 Data log: Status word No No
609 Data log: Reference No No
610 Data log: Feedback No No
611 Data log: Output frequency No No
612 Data log: Output voltage No No
613 Data log: Output current No No
614 Data log: DC link voltage No No
615 Fault log: Error code No No
616 Fault log: Time No No
617 Fault log: Value No No
618 Reset of kWh counter No reset Yes No
619 Reset of hours-run counter No reset Yes No
620 Operating mode Normal function Yes No
621 Nameplate: Unit type No No
622 Nameplate: Power component No No
623 Nameplate: VLT ordering no. No No
624 Nameplate: Software version no. No No
625 Nameplate: LCP identification no. No No
626 Nameplate: Database identification no. No No
627 Nameplate: Power component
identification no. No No
628 Nameplate: Application option type No No
629 Nameplate: Application option ordering no. No No
630 Nameplate: Communication option type No No
631 Nameplate: Communication option
ordering no. No No
Data
type
7
7
7
6
6
6
5
6
6
3
4
3
6
3
6
5
7
3
5
5
5
9
9
9
9
9
9
9
9
9
9
9
Conversion
index
74
74
2
0
0
0
0
0
0
-1
-3
-1
-1
-2
0
0
0
0
0
0
0
0
0
0
0
0
-2
0
0
0
0
0
Changes during operation:
"Yes" means that the parameter can be changed, while
the VLT AFD is in operation. "No" means that the VLT AFD
must be stopped before a change can be made.
4-Setup:
"Yes" means that the parameter can be programmed
individually in each of the four setups, i.e. the same
parameter can have four different data values. "No" means
that the data value will be the same in all four setups.
Conversion index:
This number refers to a conversion figure to be used when
writing or reading to or from a VLT AFD by means of serial
communication.
Conversion index Conversion factor
74 0.1
2 100
1 10
0 1
-1 0.1
-2 0.01
-3 0.001
-4 0.0001
Data type:
Data type shows the type and length of the telegram.
Data type
Description
3 Integer 16
4 Integer 32
5 Unsigned 8
6 Unsigned 16
7 Unsigned 32
9 Text string
Parameter list