6
July 31, 2019
CONNECTOR #6
PIN 1
— SIREN #1 SPEAKER
PIN 2
— SIREN #1 SPEAKER
PIN 3
— SIREN #2 SPEAKER (optional)
PIN 4
— SIREN #2 SPEAKER (optional)
PIN 5
— HORN
PIN 6
— HORN RING
PIN 7
— RADIO input
PIN 8
— RADIO input
CONNECTOR #7
PIN 1, 9, 10
— N/A
PIN 2
— PARK KILL input, default GROUND control. Optional positive control, see the software manual.
PIN 3
— +12V input from battery, feed used to measure the battery voltage.
PIN 4 TO 8
— logic inputs, d12V triggers. Optional programmable to GROUND triggers, see
the software manual.
CONNECTOR #8, 9, 11
—
data input used to connect touchpad, lightbar or temperature sensors.
RADIO VOLUME ADJUSTMENT
MICROPHONE VOLUME ADJUSTMENT
MICROPHONE JACK
5. LABELING INSTRUCTIONS
1. Using a Phillips screwdriver remove the 4 self-tapping screws securing the back cover of the touchpad.
2. Using a small flat screwdriver, carefully separate the front cover from the back cover.
3. Select the appropriate push button label from the enclosed label packet.
4. Orient the label in the same direction as the existing top row labels and with the top cover resting on a
flat surface, evenly apply finger pressure to the label to ensure that it has been applied properly.
5. Apply all required remaining labels in the same manner.
6. When all required labels are installed, re-install the front cover and carefully tighten the self tapping
screws securing the back cover.
HORN / HORN RING relay connection
