V-Series arrays and assembly
3. Attach the first cabinet to the frame
1. Place the cabinet onto the frame until the additional Front links
fit into the slots at the front of the cabinet.
2. Insert the second Locking pins of the additional Front links on
both sides.
4. Set the vertical aiming of the first cabinet
The hole grid on the Flying frame allows the first cabinet to be set
to a fixed vertical angle of –7°, –3.5°, 0°, +3.5° or +7°. The
hole (drill) of the cabinet's Splay link is used for this purpose. It
supports the cabinet and defines the angle setting.
1. Release the Locking pins of the cabinet's Splay link.
2. Fold out and insert the Splay link into the track of the center
bar of the frame and align the hole of the link with the desired
hole of the frame.
3. Fix the angle of the cabinet using the Locking pin of the Cable
pick.
5. Add further cabinets
1. Release the Locking pins of the Front links of the first cabinet.
2. Slide out the Front links and insert one Locking pin each to fix
them in place.
3. Attach the next cabinet to the Front links and insert the second
Locking pins on both sides.
4. At the rear, release both Locking pins of the upper cabinet's
Splay link.
5. Preset the desired splay angle on the rear rigging strand of the
bottom cabinet using one Locking pin.
6. Fold the Splay link of the upper cabinet into the rigging strand
of the bottom cabinet.
7. Raise the upper cabinet until the hook of the Splay link hooks
into the preset Locking pin.
8. Hold the cabinet in place and insert the second Locking pin
(Safety pin) to fix the Splay link in place.
To add further cabinets, proceed in the same manner until the
assembly is completed.
6. Rig the cabling
Connect the flying cables and link cables according to the number
of amplifier channels and cabinets used.
7. Check the assembly
Recheck the actual status of the entire assembly according to the
checklist given in
36 ページの 4 章 "Safety and system
d&b V-Series リギングマニュアル 1.11 ja
34
