3
(c) 2012 Z-Wave Europe GmbH, Goldbachstr. 13, 09337 Hohenstein-Ernstthal, Germany, www.zwaveeurope.com
it may be needed for certain network operations to send out a Node Information Frame.
To issue a Node Information Frame press and hold the User Button on the door lock until it beeps twice.
Set and unset associations to actuators
Associations can be assigned and remove either via Z-Wave commands or using the device itself.
SA
To confirm Association press and hold the User Button on the door lock until it beeps twice.
Configuration Parameters
Z-Wave products are supposed to work out of the box after inclusion, however certain configuration can adapt the function better
to user needs or unlock further enhanced features.
IMPORTANT: Controllers may only allow configuring signed values. In order to set values in the range 128 … 255 the value sent in
the application shall be the desired value minus 256. For example: to set a parameter to 200 it may be needed to set a value of
200 minus 256 = minus 56. In case of a two byte value the same logic applies: Values greater than 32768 may needed to be given
as negative values too.
Turning Direction (Parameter Number 1, Parameter Size 1)
parameter defines which direction the motor turns
the lock in relation to the latch
Value
Description
0
Clockwise when latching (Default)
1
Counterclockwise when latching
Turning Speed (Torque) (Parameter Number 2, Parameter Size 1)
parameter defines whether the motor goes
slower (more torque) or faster (less torque) when turning the lock
Value
Description
1
Slowest Speed, Strongest Torque
2
Slow Speed, Stronger Torque
3
Normal Speed, Normal Torque (Default)
4
Fast Speed, Weak Torque
5
Fastest Speed, Weakest Torque
Torque Setup (Parameter Number 3, Parameter Size 1)
parameter defines if more or less torque is used at
latch/unlatch operations (less torque safes power)
Value
Description
0
Less torque, Power Saving mode
1
Normal Mode (Default)
Turning degrees (Parameter Number 4, Parameter Size 1)
parameter defines how many degrees the lock turns
at latch/unlatch operations
