DANA SPICER TM4 SUMO HP HV Powertrain, Troubleshooting Manual

Page: 182 / 192

182
Troubleshooting
Tree SysFile IDs Causes (numbered in order of likely occurrence)
06 0x0319
1. 0x3113 warning occurred at the same time caused by another error
while the vehicle was in high speed (Back EMF mechanism - phase
short circuit protection engaged).
2. 0x050B error occurred due to a VMU / ECU controller that sent a
shutdown request CAN message while the motor speed was high
(phase short circuit mechanism engaged).
3. Defective MCU.
07 0x3312
0x3313
1. Defective motor.
08 0x032B
0x032C
1. MCU HVIL parameters were not correctly configured.
2. Another system opens the HVIL loop from the HVIL input of the
MCU.
3. Defective VMU/MCU interface connector on the MCU.
4. Defective MCU.
09 0x032D
0x032E
1. MCU HVIL parameters were not correctly configured.
2. Another system opens the HVIL loop from the HVIL input of the
MCU.
3. Defective VMU/MCU interface connector on the MCU.
4. Defective MCU.
10 0x032F
0x0330
1. MCU HVIL parameters were not properly configured.
2. MCU phase cables not inserted properly with locking screws
installed.
3. Motor phase cables not inserted properly with locking screws
installed.
4. DC input cables not inserted properly with locking screws installed.
5. Motor sensor cable not properly inserted properly.
6. Defective motor sensor cable.
7. Defective motor.
8. Defective MCU.
11 0x0331
0x0332
1. MCU HVIL parameters were not properly configured.
2. HVIL power source fault.
3. Defective MCU.
12 0x0312
0x0501
0x0502
0x0503
0x0504
0x0505
0x050E
0x050F
0x051B
0x051C
0x1207
0x3111
0x3300
0x3304
0x330A
0x330C
0x330D
0x4000
1. Wrong MCU connected to the motor.
2. Wrong motor type connected to the MCU.
3. Wrong software flashed to the MCU.
4. Defective MCU (Potential wrong factory settings).