Serie "EUR7"
Page 5
Rev. M - 01
I
NSTALLATION
Install the vending machine in covered and protected places where it is not exposed to
inclement weather and cannot be rained on or sprinkled with jets of water.
Place the vending machine in the point where it is to be installed, making sure that the minimum
distances shown in Figure 3 are guaranteed.
Also make sure that air can circulate freely in the rear and upper part; the room should be ventilated
regularly.
The vending machine must operate in a room that is in conformity with the information given in the table
on page 3.
Using the vending machine outside of these conditions could cause it to malfunction.
Adjust the height and alignment of the vending machine by means of the support feet with a 19 mm
open end wrench, making sure that all four of them rest correctly on the ground. When the vending
machine is not levelled properly it can be difficult to close the door.
With the “wall anchoring bracket kit” accessory it is possible to anchor the vending machine to the wall
with two special spacers (See Fig. 4), as follows:
Screw the two
“wall anchoring brackets” on the top of the vending machine (see figure) with the screw
from above and a nut from inside the machine; remove the first drawer at the top to reach the position
easily.
- Place the vending machine in the desired position and mark the position of the brackets on the wall.
- Drill the wall and fasten the brackets using expansion bolts, making sure that the brackets are
positioned correctly.
-
Position the vending machine inside the brackets and fasten it firmly with the screws from above and
the self-locking nuts from below (inside the machine).
2
Wall anchoring brackets
Drill and fasten to wall
Nut from inside vending
machine
Screws from
above
F
IGURE
4
MIN 8 CM
MIN 40
CM
MAX
±
2°
F
IGURE
3
