Serie "EUR7"
Pagina A - 6
Rev. M - 01
>
C
ODE
M
ODE
Allows to read the internal parameter software 'code mode'.
[ Read only ]
>
V
ISUALISATION OF THE
SW
VERSIONS INSTALLED
:
To visualise the software versions installed.
Press keys 1 and 2 to scroll through the versions of the various softwares.
>
C
ARD REINITIALISATION
:
To reinitialise
the vending machine‟s CPU card, for example, after replacement with a new unprogrammed
one.
Proceed as follows to reinitialise the card:
1)
enter into programming,
General parameters
, as described previously;
2)
select
Default P. Reset,
this message appears on the display:
3)
enter the value “
12345
”
and confirm with
3
, the card will delete some of the stored programming
parameters and will go automatically into
“self-learning”
mode.
The self-learning procedure occurs in the following phases:
Note: in the event of error in any point of the procedure, press the
6
key for a few seconds; the self-
learning procedure will start over from the beginning.
A)
This message appears on the display:
after selecting the desired language, press
3
to confirm
B)
This message appears on the display:
Check that the number of connected motors corresponds to those actually present in the vending machine;
if there is a discrepancy, proceed as described in the installatio
n and service manual in the “Answers to
problems that might arise” chapter, “some motors are not detected” section.
press
3
to confirm
C)
This message appears on the display:
Press
3
if you do
not
wish to set twin motors in a single selection;
Otherwise select „
Twin Motors
:
ON
‟ to set pairs of motors near each other that you wish to make run
simultaneously with a single selection.
This message appears on the display:
Select the motor that you wish to set coupled and press
3
.
Password
00000
Self-learning
Conn. motors: xx
Self-learning
Twin Motors:OFF
Selection x-x
Current value
Programming
General param.
Software vers.
->->->
3
Programming
General param.
Default P. Reset
->->->
3
Self-learning
Language:Italian
Programming
General param.
Code Mode
Current value
3
