PRELIMINARY
4M Stop Action Camera Manual
03-32-10121-09
DALSA
12
fer to section 2.2.3 Power Connector for
Figure 6: Input and Output
•
One 6-pin Hirose connector for power. Re
details.
Camera Link (Base Configuration)
Camera Link (Medium Configuration)
Diagnostic LED
+12V to +15V
CONTROL
DATA 1
DATA 2
POWER
WARNING: Ensure that all
power (irrespective of cabl
the correct voltages at full load are present at the camera end of the
e length) according to the pinout defined in section 2.2.3 Power
.2.
ith a red/green LED used to display the operational status of
ra. The table below summarizes the operating states of the camera and the
corresponding LED states.
ore tha
dition with the highest
y. Error
ing messages further
he current
Table 3: Status LED
Connector.
1 LED Status Indicator
The camera is equipped w
2
the c
LED indicate
ame
When m
n one condition is active, the
s the con
priorit
and warning states are accompanied by correspond
describing t
camera status.
Flashing Green
Camera initialization or executing a time consuming command
Solid Green
Camera is operational and functioning correctly
Flashing Red
Fatal Error. System voltage out of tolerance.
Solid Red
Warning. Loss of functionality (e.g. external SRAM failure)
2.2.2 Camera Link Data Connector
Figure 7: Camera Link MDR26 Connector
MDR26 Female
1
14
13
26
M at ing Par t
: 3M 334-31 ser ies
C able:
3M 14X 26-SZ LB-X X X -0LC
* *
The Camera Link interface is implemented as either a Base or Medium Configuration in
the stop action 4M cameras. You select the camera configuration with the
clm
command
described in section 3.3.2 Setting the Camera Link Mode .
