4M Stop Action Camera Manual
PRELIMINARY
27
3.4.3 Setting the Exposure Time
urpose:
Sets the camera’s exposure time is µs.
set f
Syntax Elements
ange is 10-999989
ts.
Notes:
de 2.
retrieve the current exp ure time, use the command
gcp
.
valid range, the input
en (
h
command) for
n exposure time which overlaps with the frame
lly adjust to int
era sends a
when this occurs. Refer to Table 11: Allowable
ure Time Increments.
Changing the exposure time will automatically adjust the frame
rate if necessary. The camera sends a warning when this occurs.
Related
mands:
sem
,
ssf
,
eec
,
clm
amp :
set 5500
Table 11: All
nts
P
Syntax:
:
µs.
f
Floating point number in µs. A
nge.
•
If you enter
owable Exposure Time Increme
llowable r
See Table 11 below for allowable incremen
•
Camera must be operating in exposure mo
•
To
os
•
If you enter an exposure time outside of a
will not be accepted. Refer to the help scre
the valid ra
a
egral
readout, the exposure time will automatica
units of exposure time increments. The cam
warning
Expos
•
Com
Ex
le
15
or
16
18.475 µs (80 MHs pix
22.875 µs (65 MHs pixel rate)
1µs
n exposure time overlaps
frame readout
when exposure time
does not
overlap frame readout
el rate)
whe
2
or
3
37.000µs (80 MHs pixel rate)
45.600 µs (65 MHz pixel rate)
1µs
when exposure time overlaps
frame readout
when exposure time
does
not
overlap frame readout
Note:
Although you must be operating the camera in exposure mode 2 to use the set
exposure time (
set
) command, the allowable exposure time increments listed above also
apply to exposure mode 4 (Smart EXSYNC) when exposure time overlaps frame readout.
DALSA 03-32-10121-09
