Dalsa spyder SG-10-01k40, User Manual

Page: 54 / 119

Spyder 3 GigE User Manual
03-032-10158-06 DALSA
54
Setting Baud Rate
Purpose: Sets the speed in bps of the serial communication port.
Syntax:
sbr m
Syntax Elements:
m
Baud rate. Available baud rates are:
9600
(Default),
19200
,
57600
, and
115200
.
Notes: •
Power-on rate is always 9600 baud.
•
The
14H
rc
(reset camera) command will not reset the camera to
the power-on baud rate and will reboot using the last used
baud rate.
Example:
sbr 57600
Camera ASCII Command Help
For quick help, the camera can return all available commands and parameters through
the serial interface.
There are two different help screens available. One lists all of the available commands to
configure camera operation. The other help screen lists all of the commands available for
retrieving camera parameters (these are called “get” commands).
To view the help screen listing all of the camera configuration commands, use the command:
Syntax:
h
To view a help screen listing all of the “get” commands, use the command:
Syntax:
gh
Notes: For more information on the camera’s “get” commands, refer to
section
283H
A4.7 Returning Camera Settings.
The camera configuration command help screen lists all commands available. Parameter
ranges displayed are the extreme ranges available. Depending on the current camera
operating conditions, you may not be able to obtain these values. If this occurs, values are
clipped and the camera returns a warning message.
Some commands may not be available in your current operating mode. The help screen
displays NA in this case.