Dalsa spyder SG-10-01k40, User Manual

Page: 92 / 119

Spyder 3 GigE User Manual
03-032-10158-06 DALSA
92
System Gain (DN): 4096 4096
Digital gain settings set
with the
137H
ssg
command.
See section
318H
A2.2 Analog
and Digital Signal
Processing Chain for
details.
GPIO Configuration Signal Mode
Input0 Disabled
Input1 Disabled
Input2 Disabled
Input3 Disabled
Output0 High Impedance
Output1 High Impedance
Output2 High Impedance
Output3 High Impedance
Current GPIO pinout
configuration. Refer to
section
319H
A1.5
Configuring the GPIO
Connector for details.
Returning Camera Settings with Get Commands
You can also return individual camera settings by inserting a “
get”
in front of the
command that you want to query. If the command has a tap or pixel number parameter,
you must also insert the tap number or pixel number that you want to query. Refer to
320H
Table 13 below for a list of available commands. To view a help screen listing the
following get commands, use the command
gh
.
Table 13: Get Commands
Syntax Parameters Description
get cao
t
Returns the analog offset for the tap indicated
t
= tap selection, either
1
to
2
depending on camera
model, or
0
for all taps
get ccf
x1 x2
Returns the FPN pixel coefficients for the pixel range
indicated.
x1
= Pixel start number
x2
= Pixel end number
get ccp
x1 x2
Returns the PRNU pixel coefficients for the pixel range
indicated.
x1
= Pixel start number
x2
= Pixel end number
get css
Returns the number of line samples averaged for pixel
coefficient calculations or for output of
gla
command.
get dgc
Returns the current GPIO configuration.
get dpc
x1 x2
Returns pixel coefficients without formatting.
get els
Returns whether the end-of-line statistics are turned off or
on.
0
: Off
1
: On