Dalsa spyder SG-10-01k40, User Manual

Page: 89 / 119

Spyder 3 GigE User’s Manual
DALSA 03-032-10158-06
89
A4.7 Returning Camera Settings
Returning All Camera Settings with the Camera Parameter
Screen
The camera parameter (gcp) screen returns all of the camera’s current settings. The table
below lists all of the gcp screen settings.
To read all current camera settings, use the command:
Syntax:
gcp
GCP Screen Description
GENERAL CAMERA SETTINGS
Camera Model No.: SG-10-02K80
Camera model number.
Camera Serial No.: xxxxxxxxx
Camera serial number.
Firmware Version: xx-xx-xxxxx-xx
Firmware design
revision number.
CCI Version: xx-xxx-xxxxx-xx
CCI version number.
FPGA Version: xxx.xx
FPGA revision number.
UART Baud Rate: 115200
Serial communication
connection speed set
with the
120H
sbr
command.
See
297H
Setting Baud Rate
on page
298H
54 for details.
Dual Scan Mode: High Sensitivity
Current sensitivity
mode set with the
121H
shm
command. See section
299H
A1.1 Sensitivity Mode
for details.
Camera Mode: 2 taps, 12 bits
Current bit depth
setting set with the sdm
command. Refer to
section
300H
A1.3 Setting the
Bit Depth for details.
Readout Mode: Off
Current readout mode
status. Set using the srm
command.
Exposure Mode: 7
Current exposure mode
value set with the
122H
sem
command. See section
301H
A1.4 Exposure Mode,
Readout Mode, Line
Rate and Exposure
Time for details.
SYNC Frequency: 5000.00 Hz
Current line rate. Value
is set with the
123H
ssf
command. See section
302H
A1.4 Exposure Mode,
Readout Mode, Line
Rate and Exposure
Time for details.