Dalsa C1240, User Manual

Page: 174 / 327

164 • Operational Reference Nano Series GigE Vision Camera
Cycling Preset Mode Control Category
The Genie Nano Cycling Preset control as shown by CamExpert has parameters used to configure
the camera Cycling features. Cycling controls allow the user to configure a number of camera
operational states and then have the camera automatically switch between states in real-time.
Only the features programmed to change are updated when switching between camera states, thus
ensuring immediate camera response. A setup example follows the feature table.
Parameters in gray are read only, either always or due to another parameter being disabled.
Parameters in black are user set in CamExpert or programmable via an imaging application
Features listed in the description table but tagged as Invisible are usually for Teledyne DALSA or
third party software usage—not typically needed by end user applications. Also important,
Genie Nano cameras are available in a number of models implementing different sensors and
image resolutions which may not support the full feature set defined in this category.
Note: This feature set is not available with the Nano C4900 (rolling shutter) camera.