Dalsa C1240, User Manual

Page: 161 / 327

Nano Series GigE Vision Camera Operational Reference • 151
Advanced Processing Control Category
The Genie Nano Advanced Processing controls, as shown by CamExpert, groups parameters used
to configure LUT mode controls on monochrome cameras. Parameters in gray are read only, either
always or due to another parameter being disabled. Parameters in black are user set in CamExpert
or programmable via an imaging application.
Features listed in the description table but tagged as Invisible are usually for Teledyne DALSA or
third party software usage—not typically needed by end user applications.
Also important, Genie Nano cameras are available in a number of models implementing different
sensors and image resolutions which may not support the full feature set defined in this category.
Advanced Processing Control Feature Descriptions
The following table describes these features along with their view attribute and device version. For
each feature the device version may differ for each camera sensor available. Such feature
differences will be clearly indicated.
As Genie Nano capabilities evolve the device firmware version will increase, therefore identifying
the supported function package. New features for a major device version release will be indicated
by green text for easy identification, for that new manual release.
The description column will indicate which feature is a member of the Teledyne DALSA Features
Naming Convention (indicated by DFNC), versus the GenICam Standard Features Naming
Convention (SFNC not shown).