Dal Zotto INSERTO 700 2.0, User Manual

Page: 47 / 164

47 ENGLISH
ASSEMBLY WITH SLIDING BASE
Take the sliding base and position it in the pre-existing flue. Use chalk to mark the blocking holes of the base on the flue surface. Drill 8 mm
holes for the steel expansion inserts.
Make a hole measuring 60 mm in line with the air intake.
Remember the power socket on the rear of the insert so that the plug is accessible once installation is completed.
Fix the base using the clamping screws.
Create a flue exhaust and socket connection respecting the points described previously.
Take the insert, tilt it so that the wheels fit into the relative rails, make it run until the flue gas insert is completely inserted into the flue gas
conveyor box.
PEDESTAL ASSEMBLY (OPTIONAL):
Position the base in the desired point and use the feet to adjust the desired height (the bolts are positioned in the four external sides of the
pedestal in the lower part).
Remember the power socket on the rear of the pedestal so that the plug is accessible once installation is completed.
Fix the pedestal to the floor using strong steel plugs with a diameter of 8 mm.
Fix the sliding base to the frame using bolts.
Connect the flue gas exhaust pipe and the air vent as stated in the previous paragraph.
Take the insert, tilt it so that the wheels fit into the relative rails, make it run until the flue gas auger is completely inserted into the flue gas
conveyor box.
Finally open the fire door and use the supplied Allen key to turn the screw at the bottom left corner clockwise.
To understand whether the insert is correctly attached to the base, connect the plug to the socket and make sure the display switches on.
N.B.: If our pedestal is used, a slot must be created in the flue that allows
the pellet level in the feed-box to be checked, thus preventing spillage
during filling.