Mechanical Installation
4
2 Mechanical Installation
All decisions regarding display setup must conform to the specifications and guidelines
in this section. Read both the mechanical and electrical installation sections before
beginning any installation procedures.
Table Setup
Reference Drawings:
Mechanical Specs; ST-2363/2373 ...................................................................
DWG-3462318
Move the table(s) to the desired location. This will typically be within 10' (3 m) of a power
outlet.
• If there is only one table, skip ahead to
.
•
If there is more than one table, first refer to
Multiple Table Connection (p�4)
Multiple Table Connection
If more than one scorer’s table is to be used as part of a single display face, they must
be lined up in the appropriate arrangement and attached to each other. One table
attaches to another using three latches on the right-hand side of the table (as viewed
from the rear). There is one latch in the cable tray (1), one latch on the rear of the caster
base (2), and one latch on the lower-front corner of the caster base (3). Refer to
for the location and detail of these latches.
1
2
3
Figure 4:
Latch Locations & Detail
