Mechanical Installation
7
Tabletop Setup
The tabletop should be upright only during games and events, and it should be in
the dropped position when moving and storing the table. The following steps can be
performed with one person but are easiest with two people. The tabletop capacity is
rated at a maximum of
150 lb (68 kg)
.
To set up the tabletop:
1�
With the table(s) in their desired location (and latched together), move to the rear
and depress both rear caster locking brakes
for each table
.
Note:
Before moving the table(s), always ensure the rear caster brakes are in the
unlocked position.
2�
Starting with the tabletop in the dropped position as shown in
, stand in the
middle of one table and lift the tabletop upward as shown in
.
3�
While holding the tabletop in the upright position,
insert a 5/16" T-handle wrench (Daktronics part # TH-
1088) into the nearest of the four tabletop latch holes
located in the bottom of the cable tray as shown in
.
4�
Rotate the wrench clockwise to engage the latch.
. Move on to the next latch location
until all four latches are engaged.
Note: The wrench must be rotated 285° or a little
over a 3/4 turn to fully engage the latch� All
four latches must be used and fully engaged
to support the rated load listed�
5�
Repeat
Steps 2–4
for all remaining tables.
Figure 10:
Tabletop Dropped
Figure 11:
Lifting Up & Holding Tabletop
Figure 12:
Rotating Wrench
