Introduction
1
1 Introduction
Reference Drawings:
System Riser Diagram: Single Pole (SP).............................................................
DWG-093476
System Riser Diagram: Momentary ...................................................................
DWG-096221
System Riser Diagram: BCD Switch ...................................................................
DWG-096315
System Riser Diagram: Rotary ............................................................................
DWG-097099
How to Use This Manual
This manual explains the installation, operation, maintenance, and troubleshooting of
the SI-32 (Switch Interface - 32 Input). For questions regarding the safety, installation,
operation, or service of this system, please refer to the telephone numbers listed on the
cover page of this manual.
Important Safeguards:
1.
Read and understand these instructions before installing.
2.
Do not drop the SI-32 or allow it to get wet.
3.
Be sure the display is properly grounded.
4.
Disconnect power to the sign when it is not in use.
5.
Disconnect power when servicing the sign.
The manual contains five sections:
Introduction
,
Mechanical and Electrical Installation
,
Operation
,
Maintenance and Troubleshooting
, and
Reference Drawings
.
• Introduction
covers the basic information needed to make the most of the rest
of this manual. Take time to read the entire introduction as it defines terms and
explains concepts used throughout the manual.
• Mechanical and Electrical Installation
provides general guidance on terminating
power and signal cable at the sign.
• Operation
provides general information on using the Venus
®
1500 Software with
the Switch Interface, and the type of switch modes.
• Maintenance and Troubleshooting
addresses such topics as care of the unit,
troubleshooting the unit, and performing general maintenance.
• Reference Drawings
includes the drawings referenced in this manual.
Daktronics identifies manuals by the ED or DD number located on the cover page of
each manual. For example, this manual is referred to as
ED-10606
.
illustrates Daktronics’ drawing numbering system. This number is located in the
lower-right corner of the drawing. The manual refers to drawings by listing the last five
digits and the letter preceding them. In the example below, the drawing would be
referred to as
DWG-069945
.
Figure 1:
Drawing Label
