Display and Control Overview
5
2 Display and Control Overview
This section describes generic power and signal paths for Daktronics digital billboards.
Refer to display-specific signal and riser drawings for component locations on your
display.
Display Control System Flow Overview
ISP enclosure and the SmartLink
TM
power control device. The control
system bay or components may
vary slightly by display. Refer
to project-specific drawings for
display control location, signal
path, and power path.
Display Power
Overview
Each 400W power supply powers 10
modules in DB-65 series billboards.
Power to the display section enters into the termination panel and is redistributed to the
power supplies. Refer to the layout drawing for display-specific power distribution.
Display Signal Overview
Signal is sent from the DMP-8000 to the VIP-5160. The VIP-5160 sends signal to the PLR,
which sends the signal to the first module in the section. From that module, the signal is
sent to the other modules in the section. The PLR not only sends signal to the first module
in the chain but also receives signal from the last module in the chain and creates a
redundant signal path.
See Block Diagrams DWG-04269758, DWG-04269759, and DWG-04269760 in
Spare Parts
Location
Doors
Control System
Location
Border
Module
Support
Ledger
Display Front
Ventilation Exhaust
Ventilation
Intake
Term
Panel
Power
Entrance
Display Back
Figure 6:
65 Series Control Components