3
MAN# 650665:A
Gauge installation:
(with factory electronic speed sensor)
1. Remove the dash
2. Unclip and unplug the factory gauge
3. Ensure the rubber gasket is in place on the dash;
the MLX-2000 requires this factory piece.
4. Insert the new gauge from front of dash and use
supplied L-brackets, lock washers and screws to
secure the gauge.
5. Before fully tightening the screws, plug in the main harness
and turn the key on so you can align the gauge.
6. Tighten the screws.
7. If you’d like to add standard indicators, oil pressure, oil temperature,
air pressure, boost or compass readings to the MLX-2000, connect
the applicable harnesses and route to their appropriate locations;
MBM modules may fit under the seat.
8. Skip to page 5 and complete all electrical aspects of the installation
before reinstalling the dash.
Factory Dash Panel
Factory Gasket
Dakota Digital
MLX-2000
#8 Lock Washers
8-32 x ½” Screws
L-Brackets (supplied)
