4
MAN# 650665:A
Gauge installation:
(Deuce only)
NOTE: The supplied L-bracket mounting pieces are not used for this application and can be discarded
Since the Deuce gauge mounts from under the dash mounting requires use of the supplied mounting ring.
1. Remove the dash
2. Unclip and unplug the factory gauge
3. Remove the rubber gasket from the factory gauge bezel.
4. Fit the gasket over the bezel of the MLX-2000. Only the
inner, raised portion of the front bezel will be exposed
while the entire back of the bezel is covered by the gasket.
5. Place the mounting ring over the back of the gauge
so the gauge fits in the recessed pocket. Align the screw
and connector reliefs for proper orientation. Use the two
8-32 screws and lock washers to secure the bracket to
the gauge; this will align the gauge properly in the dash.
6. Snap the gauge into the dash starting with one tab in and,
working in a clockwise direction, snap the other two tabs in
one at a time. The tabs are tight so it takes a fair amount
of pressure to snap them in. Make sure the tabs are seated
in the notches of the dash once locked in.
7. Skip to page 5 and complete all electrical aspects of the installation
before reinstalling the dash.
Factory dash
panel
Factory bezel
gasket
Dakota Digital
MLX-2000
Mounting ring (supplied)
#8 Lock washers
8-32 x ½” screws
Mounting notches
(cast in dash)