Dakota Digital BIM-01-2, Quick Start Manual

Page: 9 / 12

[9] MAN #650500G
BIM setup continued:
Enable or disable gear position output from the BIM-01-2
•
Hold the switch on the BIM-01-2 case while turning the key on. The BIM display will show the current revision
code while this is held.
•
Release the switch.
•
Tap the switch until the display shows
“  ” (gear position). Press and hold to enter this menu.
•
When you see
“  ” on the display release the switch.
•
The display will show the current state of the gear position

* (enable) or

(disable).
•
Tap the switch to change the state.
•
To save setting press and hold the switch until you see
“  ” on the display, then release the switch.
• The display will show “  ”. Press and hold the switch to exit setup or tap to choose another menu option.
Enable or disable vacuum/boost output from the BIM-01-2
**Note: This reading is taken from the MAP sensor. A functional MAP sensor is required for an accurate reading. Vacuum
reading is in inHg and boost is in PSI.
•
Hold the switch on the BIM-01-2 case while turning the key on. The BIM display will show the current revision
code while this is held.
•
Release the switch.
•
Tap the switch until the display shows
“  ” (boost). Press and hold to enter this menu.
•
When you see
“  ” on the display release the switch.
•
The display will show the current state for boost enable

* (enable) or

(disable).
•
If turning

ensure the BIM is connected to a VHX/HDX/VFD3/RTX system because the BIM will automatically
choose a BIM channel on the system.
•
Tap the switch to change the state.
•
To save setting press and hold the switch until you see
“  ” on the display, then release the switch.
• The display will show “  ”. Press and hold the switch to exit setup or tap to choose another menu option.
Enable RPM signal for Ford Performance control pack/Coyote Engines
**Note: It is recommended to use the default setting
(

) . Only enable this setting if your RPM signal is not functioning.
•
Hold the switch on the BIM-01-2 case while turning the key on. The BIM display will show the current revision
code while this is held.
•
Release the switch.
•
Tap the switch until the display shows
“  ” (TACH). Press and hold to enter this menu.
•
When you see
“  ” on the display release the switch.
•
The display will show the current state

(standard) or

(Ford).
•
Tap the switch to change the state.
•
To save setting press and hold the switch until you see
“  ” on the display, then release the switch.
• The display will show “  ”. Press and hold the switch to exit setup or tap to choose another menu option.
Enable Speed signal for Ford Performance control pack/Coyote Engines
**Note: It is recommended to use the default setting
(

) . Only enable this setting if your Speed signal is not functioning.
•
Hold the switch on the BIM-01-2 case while turning the key on. The BIM display will show the current revision
code while this is held.
•
Release the switch.
•
Tap the switch until the display shows
“  ” (SPEED). Press and hold to enter this menu.
•
When you see
“  ” on the display, release the switch.
•
The display will show the current state

(standard) or

(Ford).
•
Tap the switch to change the state.
•
To save setting press and hold the switch until you see
“  ” on the display then release the switch.
• The display will show “  ”. Press and hold the switch to exit setup or tap to choose another menu option.