Configuration password
This feature is used to prevent unauthorized access to the configuration of
the switch. To change the configuration password, highlight the configura-
tion password field and hit enter. You will be prompted for a new password.
Enter up to 8 characters followed by enter. Another input box appears and
asks you to confirm the password. The next time you enter the configura-
tion menu you will be prompted for the password.
Access password
This feature is used to prevent unauthorized access to the computers. To
change the access password, highlight the configuration password field
and hit enter. You will be prompted for a new password. Enter up to 8 char-
acters followed by enter. Another input box appears and asks you to con-
firm the password. When the switch powers on or you have otherwise been
disconnected, you will be asked for the access password from a login box.
Locking the keyboard
You can disconnect from the current computer by entering the control L
command. This disconnects the current computer and displays a login box
which requires a password to gain access to the previously connected
computer.
Access time
This feature is used to automatically log out of the switch after a period of
time. The period of time is programable with the access time field. To
change the time, highlight the access time field and hit enter. You will be
prompted for a value in minutes. Enter up to 999 minutes followed by enter.
The access time starts when there is no keyboard or mouse activity. When
the timer elapses you will be disconnected and be required to enter the ac-
cess password from the login box to gain access to the computers.
Resetting the passwords
If you forget your password, you can reset it. You must power off the
UltraView Pro, open the box, and put a jumper on the password reset pins
on the bottom card. It is marked on the printed circuit board. No jumper has
been provided to prevent inadvertent disabling of the password. You must
provide the jumper. After powering on the unit again, it will then act as if no
passwords are present. Go to the configuration menu and enter new pass-
words and save them. Power off the unit and remove the jumper. After pow-
ering on the unit again, the new passwords will be active.
27
ULTRAVIEW PRO INSTALLATION AND OPERATION MANUAL