GB
157
8.
Lock the base using the locking
screw. The LED will stop flashing
red indicating that the anti-
removal magnet has been
properly positioned.
If this is not
the case, perform steps 4 to 6
again.
Pozidriv 2
9. A.
To insert the cables (10 mm Ø max), remove
the grommets and use a cross-headed
screwdriver to put a hole in them big
enough to accommodate the wire
diameter.
C.
Connect the wires as required.
B.
Cut the cables to the required length and then thread them into the grommets.
Strip the ends of the wires as shown below:
Outputs 1 and 2
Earthing terminal block
Outputs 3 to 8
• External power supply terminal
block
• Anti-tamper loop connection
terminal block
11 mm+/-1mm
▼
▼
7 mm+/-1mm
▼
▼
