205
GB
The receiver can recognise up to 4 control
devices (remote controls or keypads) for
controlling the hardwired control panel. It
automatically allocates an identification number
(from 1 to 4) to each control device.
Example:
recognition programming of two control devices.
1.
Select the display menu as shown below:
ƒ
The screen shows confirmation of recognition programming:
Control 1
Acknowledged
3.
Press the
t
button. The screen displays:
Control 2
reception wait
ƒ
The screen shows confirmation of recognition programming:
Control 2
Acknowledged
Programming
>
Recognition
Recognition
>
Detectors
Recognition
>
Control device
2.
Press and hold the “OFF” key on the first control device (remote control
or keypad) until the receiver responds with a confirmation beep (within
10 seconds max.).
)
)
)
)
)
or
)
)
)
)
)
or
4.
Now press and hold the “OFF” key on the second control device
(remote control or keypad) until the receiver responds with a
confirmation beep (within 10 seconds max.).
4.2 Control device recognition programming
IMPORTANT
• It is only possible to use control devices to control the hardwired control panel when the
hardwired control panel control output and connection status verification input are
connected.
• It is also possible to programme the remote control keys programmed with control codes 21,
23, 25, 27 and 33 to be recognised as “control devices” in order to control hardwired control
arming/disarming. To do this, please refer to the remote control manual.
• For a keypad to be recognised, it must be in “Installation” mode. When the keypad is
powered it is in “User” mode. To put it in “Installation” mode, follow the instructions
provided in the keypad manual.
OK
Programming
>
Recognition
t
Recognition
>
Detectors
OK
Recognition
>
Control device
OK
Control recog.
>
Auto-recognition
Control 1
reception wait
Summary of Contents for 785-21X
Page 1: ......
