Daikin VKM50GAV1, Service Manual

Page: 41 / 107

Operation Si71-812
32 Operation
Example :
Set the time to “8”.
↓
“ ” will display.
Starts operation 8 hours after the reservation is complete.
The reservation is cancelled after operation starts.
•
Set the start time while the unit is stopped.
•
The remaining time will count at the same time after reservation is complete.
See the example below if you want to reserve “off after time” and “on after time” at the same time.
For example : (Refer to Fig. below)
When the timer is programmed to stop the system after 3 hours and start the system after 4 hours, the
system will stop after 3 hours and start 1 hour later.
Example :
•
Setting “off after 3 hours” and “on after 4 hours” will
↓
•
Operation will stop after 3 hours.
Operation will then start in 1 hour from the time it stopped.
How to Program and Set the Timer with the Remote Controller “ BRC1D527 ”
•
The controller is equipped with a schedule timer that enables the user to operate the installation
automatically; setting the clock and day of the week is required to be able to use the schedule timer.
•
To set up clock, refer to the operation manual of the remote controller.
Browse to Monday by pressing the “ ” button.
The “ ” icon appears, “ ” will blink and one of the “ ” icons, one of the
“ ” icons might be displayed but all other fields remain blank, indicating that no
actions are programmed for Monday.
Enter the program mode by holding down the “
” button for 5 seconds, the “ ” icon will now
blink too.
Press the “
” button to activate the first programmed action.
A blinking “ 1 ” is displayed indicating that the first programmed action for Monday is being
programmed ; The set temperature and clock display are blinking.
Enter the time when the action must start using the “
” & “ ” buttons (min. step
= 10 minutes).
Press the “
” button to display the next programmed action. If a second action is programmed
for Monday, “ ” will still be blinking and “ 1 2 ” will appear.
Assuming that 5 actions were programmed for Monday, a total of 5 presses will be required to
display all programmed actions.
Enter the time when the action must stop using the “
” & “ ” buttons (min. step
= 10 minutes).
Press the “
” button. “ OFF ” icon displays.
This icon means the unit will stop at the set time.
When all data for the schedule timer actions for Monday are entered, you must confirm the
programmed actions.
Make sure the last schedule timer action you want to keep is selected (schedule timer actions with a
higher number will be deleted).
8hr
hr
hr
UNIT No.
GROUP
Remote controller for VKM BRC1D527 (EU only)
1,2,4
7,8
3,5 6
1
2
3
3
4
5
6