Daikin VKM50GAV1, Service Manual

Page: 40 / 107

Si71-812 Operation
Opration 31
Programming Start and Stop of the System with Timer
How to Program and Set the Timer with the Remote Controller “ BRC1A62 ”
•
The timer is operated in the following two ways.
Programming the stop time “ ”. The system stops operating after the set time has elapsed.
Programming the start time “ ”. The system starts operating after the set time has elapsed.
•
The start and the stop time can be simultaneously programmed.
Press the timer mode start/stop button “ ” several times and select the mode on the display.
•
For setting the timer stop “ ”
•
For setting the timer start “ ”
Each time the button is pushed, the indication changes as shown below.
Press the programming time button and set the time for stopping or starting the system.
Each time this button is pressed, the time advances or goes backward by 1 hour.
•
The timer can be programmed for a maximum of 72 hours.
•
Each time when “ ” is pushed, the time advances one hour.
Each time when “ ” is pushed, the time goes back one hour.
Press the timer on/off button.
The timer setting procedure ends. The display “
” or “ ” changes from flashing light
to constant light.
•
After the timer is programmed, the display shows the remaining time.
•
For cancelling the timer operation, push the timer on/off button “ ” once again.
The indication disappears.
Note
•
When setting the timer off and on at the same time, repeat the above procedure (from “ ” to
“ ”) once again.
„
DETAIL EXPLANATION
When you want to stop operation after a desired time,
Example :
Set the time to “8”.
↓
“ ” will display.
Stops operation 8 hours after the reservation is complete.
The program will be cleared after the operation stops.
•
Set the stop time during operation.
When you want to start operation after a desired time has elapsed
1
3
2
Remote controller for VRV BRC1A62
6 2
1
“No indication”
“ ” “ ”
2
3
1
3
8hr